FEATURES & BENEFITS
• Three step, fully automatic switch mode model.
• Charges lead-acid batteries (Wet, MF, GEL and AGM) from
1.2Ah to 120Ah.
• Maintenance pulse charging increases battery life and
gives superb performance.
• Charges even drained batteries.
• Pulse recover of slightly sulphated batteries.
• Three unique charging modes for use on small batteries,
large batteries and a special cold mode that is also suitable
for AGM batteries.
• Low back current drain, low ripple and input voltage
independent (170-260V).
• High efficiency: 85%
• Delivered with two interchangeable connection leads,
one with clamps, and one with eyelet terminals.
• The charger can by connected for months, ideal for seasonal
vehicles.
• Compact design with mounting holes for permanent assembly.
• 2 year warranty.
SAFETY FEATURES
• Electronic safe, the charger will not damage vehicle
electronics. The battery does not normally need to be disconnected
from the vehicle when charging.
• Minimal gas build-up and a patent-pending spark protection
system.
• Short circuit and reverse polarity protected.
• Double insulation.
• Splash and dust proof (IP65) and approved for outdoor
use.
• Progressive temperature protection.
• Tested and approved by Intertec SEMKO AB. S-marked and
conforms to the following standards:
EN 60335-1, EN 60335-2-29, EN 55014-1, EN 55014-2, EN 61000-3-2,
EN 61000-3-3, EN 60555-2.
CHARGING CHARACTERISTICS
The MULTI XS 3600 has a fully automatic, three step charge,
IoUoUp:

1. Bulk
Charging where 80% of the energy is returned. The charger delivers
a constant current until the battery voltage has reached the
set level.
2. Absorption
Final part of the charge up to 100%. The battery voltage is
kept constant at the set level, during which time the currentdrops
gradually.
3. Pulse
Maintenance charging. The state of charge varies between 95%
and 100%. A pulse is sent out to the battery if the voltage
drops. This keeps the battery in trim when not in use. The charger
can be connected for months at a time.
Using the MULTI XS 3600 gives your battery an optimum service
life and operational reliability.
TECHNICAL DATA
MODEL MULTI XS 3600
| Model |
MULTI XS 3600 |
| Input voltage |
170-260VAC, 50-60Hz |
| Output voltage |
Nominal: 12V |
| Efficiency |
85% |
| Charging voltage |
14.4V/0.8A, 14.4V/3.6A, 14.7V/3.6A |
| Charging current |
3.6A max |
| Back current drain* |
1.3mA |
| Ripple** |
Max 50mV rms, 0.13A |
| Ambient temperature |
-20°C to +50°C, output power is reduced automatically
at higher temperatures. |
| Type of charge |
Three step, fully automatic IoUoUp, switch mode with pulse
maintenance. |
| Type of batteries |
12V lead-acid batteries (Wet, MF, AGM and GEL) |
| Battery capacity |
1.2 -120Ah |
| Dimensions (L x W x H) |
165x61x38mm |
| Insulation |
IP 65 (splash and dust proof), outdoor use |
| Weight |
0.5 |
**) Ripple denotes the amount of interference there is to the
current and voltage. A high current ripple heats the battery
and shortens its life. A linear charger has a current ripple
of 70 - 400% which is much larger than the maximum 5% for a
modern sealed battery. Voltage ripple could harm other equipment,
which is connected to the battery. The MULTI XS 3600's ripple
is only 2%. The battery gains a long service life and there
is no risk of damage to other electronic devices connected to
the battery.
*) Back current drain is what drains the battery if the charger
is connected without the power cord connected. The MULTI XS
3600's extremely low back current drain corresponds to 1Ah per
month. Many other chargers have 1Ah per day.
MOUNTING
The charger is easily fitted in place using two screws.
The diameter of the mounting holes is 4.5mm located as shown
in the image. The image also shows the dimensions of the charger.

EQUIPMENT
The MULTI XS 3600 is delivered with two different battery leads,
one with clamps and one with eyelet terminals, all colour coded
for easy +/- identification.
If the battery is difficult to access, the lead with eyelet
terminals can be mounted to the battery, and the quick connectors
are located so that it is easily reached for charging.
You can also purchase additional leads allowing you to have
one lead with eyelet terminals fixed to all your vehicles with
batteries that are difficult to get at, and charge them simply
from the same charger.